NSPE Code of Ethics Case Study (The Ford Pinto)

“The Ford Pinto case is mentioned in most Business Ethics texts as an example of Cost-Benefit analysis, yet in those formats any appreciation of the complexity surrounding the issues of such decisions is overly simplified. As a thorough study, this book provides material that enriches the entire idea of
using a particular case as an avenue of learning about Ethics, Business, Society, Technology, and Government Regulation. Rather than as a mere reference tool for educators and other professionals, this book could be successful in the classroom in a way that no other anthology or collection of short case studies could be.” – Greg Pasquarello, Neumann College
It was the late 60s, when the demand for sub-compacts was rising on the market. Iacocca’s specifications for the design of the car were uncompromising: “The Pinto was not to weigh an ounce over 2,000 pounds and not cost a cent over $2,000.” During design and production, however, crash tests revealed a serious defect in the gas tank. In crashes over 25 miles per hour, the gas tank always ruptured. To correct it would have required changing and strengthening the design. Many studies of reports and documents done by Mother Jones on rear-end collisions involving Pintos reveal that if you ran into that Pinto you were following at over 30 miles per hour, the rear end of the car would buckle like an accordion, right up to the back seat. The tube leading to the gas-tank cap would be ripped away from the tank itself, and gas would immediately begin sloshing onto the road around the car. The buckled gas tank would be jammed up against the differential housing (that big bulge in the middle of your rear axle), which contains four sharp, protruding bolts likely to gash holes in the tank and spill still more gas. Now all you need is a spark from a cigarette, ignition, or scraping metal, and both cars would be engulfed in flames. If you gave that Pinto a really good whack?say, at 40 mph – chances are excellent that its doors would jam and you would have to stand by and watch its trapped passengers burn to death. In pre-production planning, engineers seriously considered using in the Pinto the same kind of gas tank Ford uses in the Capri. The Capri tank rides over the rear axle and differential housing. It has been so successful in over 50 crash tests that Ford used it in its Experimental Safety Vehicle, which withstood rear-end impacts of 60 mph. So why wasn’t the Capri tank used in the Pinto? Or, why wasn’t that plastic baffle placed between the tank and the axle – something that would have saved the life’s hundreds of people. President Semon “Bunky” Knudsen, whom Henry Ford II had hired away from General Motors, and Lee Iacocca, a spunky Young Turk who had risen fast within the company on the enormous success of the Mustang. Iacocca saying was that the Japanese were going to capture the entire American subcompact market unless Ford put out its own alternative to the VW Beetle. Bunky Knudsen said let them have the small-car market, but he lost the battle and later resigned. Iacocca became president and almost immediately began a rush program to produce the Pinto. Lee Iococca wanted that little car in the showrooms of America with the 1971 models. So he ordered his engineering vice president, Bob Alexander, to oversee what was probably the shortest production planning period in modern automotive history. The normal time span from conception to production of a new car model is about 43 months. The Pinto schedule was set at just under 25.
When it was discovered the gas tank was unsafe, did anyone go to Iacocca and tell him? “Hell no,” replied an engineer who worked on the Pinto, a high company official for many years, who, unlike several others at Ford, maintains a necessarily clandestine concern for safety. “That person would have been fired. Safety wasn’t a popular subject around Ford in those days. Whenever a problem was raised that meant a delay on the Pinto, Lee would chomp on his cigar, look out the window and say ‘Read the